JLG 600SC_660SJC Operator Manual - Manual (Page 85)

SECTION 6 - GENERAL SPECIFICATIONS & OPERATOR MAINTENANCE
3121606 – JLG Lift – 6-3
Engine Data Hydraulic Oil
NOTE: Hydraulic oils must have anti-wear qualities at least to API Ser-
vice Classification GL-3, and sufficient chemical stability for
mobile hydraulic system service. JLG Industries recommends
Mobilfluid 424 hydraulic oil, which has an SAE viscosity index of
152.
NOTE: When temperatures remain below 20° F (-7 degrees C), JLG
Industries recommends the use of Mobil DTE 13M.
Aside from JLG recommendations, it is not advisable to mix oils of
different brands or types, as they may not contain the same
required additives or be of comparable viscosities. If use of
hydraulic oil other than Mobilfluid 424 is desired, contact JLG
Industries for proper recommendations.
Table 6-3. Deutz D2011L04 Specifications
Fuel Diesel
Oil Capacity
Cooling System
Crankcase
Total Capacity
5 Quarts (4.5 L)
11 Quarts (10.5 L) w/Filter
16 Quarts (15 L)
Idle RPM 1000
Low RPM 1800
High RPM 2500
Alternator 60 Amp, belt drive
Battery 950 Cold Cranking Amps, 205 Minutes
Reserve Capacity, 12 VDC
Fuel Consumption 0.65 GPH (2.46 lph)
Horsepower 49
Table 6-4. Hydraulic Oil
HYDRAULIC SYSTEM OPERATING
TEMPERATURE RANGE
SAE VISCOSITY GRADE
+0° to +180° F (-18° C to +83° C) 10W
+0° F to +210° F (-18° C to +99° C) 10W-20, 10W-30
+50° F to +210° F (+10° C to +210° C) 20W-20