General -12, General – JLG 600SC_660SJC Operator Manual User Manual
Page 32
SECTION 2 - USER RESPONSIBILITIES, MACHINE PREPARATION, AND INSPECTION
2-12
– JLG Lift –
3121606
General
Begin the "Walk-Around Inspection" at Item 1, as noted on
the diagram. Continue checking each item in sequence for
the conditions listed in the following checklist.
TO AVOID POSSIBLE INJURY, BE SURE MACHINE POWER IS OFF.
INSPECTION NOTE: On all components, make sure there are no
loose or missing parts, that they are securely fastened, and no visi-
ble damage, leaks or excessive wear exists in addition to any other
criteria mentioned.
1.
Platform Assembly and Gate - Footswitch works prop-
erly, not modified, disabled or blocked. Latch, stop, and
hinges in working condition.
2.
Platform & Ground Control Consoles - Switches and
levers return to neutral, decals/placards secure and legible,
control markings legible.
3.
Rotator - See Inspection Note.
4.
Jib (If Equipped) - See Inspection Note.
5.
Dual Capacity Limit Switch, Transport Position Limit
Switch - Switches operate properly.
6.
Power Track - See Inspection Note.
7.
Turntable Bearing and Pinion - No evidence of loose
bolts or looseness between bearing and structure. See
Inspection Note.
8.
Tracks - Properly secured plates, no loose or missing track
bolts, no dislocation of the track pins. Proper tension. See
Inspection Note.
9.
Final Drive, Both Sides - See Inspection Note.
10.
Turntable Lock - Operable; See Inspection Note.
Figure 2-5. Daily Walkaround Inspection Points - Sheet 1 of 2