JLG 800A_AJ Operator Manual - Manual (Page 109)

SECTION 6 - GENERAL SPECIFICATIONS & OPERATOR MAINTENANCE
3121209 – JLG Lift – 6-1
SECTION 6. GENERAL SPECIFICATIONS & OPERATOR MAINTENANCE
6.1 INTRODUCTION
This section of the manual provides additional necessary
information to the operator for proper operation and mainte-
nance of this machine.
The maintenance portion of this section is intended as infor-
mation to assist the machine operator to perform daily main-
tenance tasks only, and does not replace the more thorough
Preventive Maintenance and Inspection Schedule included
in the Service and Maintenance Manual.
Other Publications Available:
Service and Maintenance Manual - ANSI, CSA Spec3120740
Service and Maintenance Manual - CE Spec........... 3120858
Illustrated Parts Manual - ANSI, CSA Spec
Prior to S/N 0300069000....................................... 3120741
Illustrated Parts Manual - CE Spec
Prior to S/N 0300069000....................................... 3120859
Illustrated Parts Manual - ANSI, CSA Spec
S/N 0300069000 to Present.................................. 3121176
Illustrated Parts Manual - CE Spec
S/N 0300069000 to Present.................................. 3121854
6.2 OPERATING SPECIFICATIONS
Table 6-1. Operating Specifications
Travel Speed
2WD
4WD
3.0 MPH (4.83 Km/hr.)
3.0 MPH (4.83 Km/hr.)
Gradeability
2WD
4WD
30%
45%
Turning Radius (Outside)
2WS
4WS
22 ft.- 6 in. (6.86 m)
14 ft.- 6 in. (4.42 m)
Turning Radius (Inside)
2WS
4WS
12 ft.- 0 in. (3.66 m)
11 ft.- 0 in. (2.13 m)
Overall Width 8 ft.-0 in. (2.44 m)
Machine Height Stowed 9 ft. 9.5 in.(2.98 m)
Machine Length (Stowed)
800A
800AJ
36 ft.-9 in. (11.25 m)
36 ft.-6 in. (11.13 m)
Wheel base 10 ft.- 0 in. (3.05 m)