JLG 800A_AJ Operator Manual - Manual (Page 138)

SECTION 6 - GENERAL SPECIFICATIONS & OPERATOR MAINTENANCE
6-30 – JLG Lift – 3121209
• any damage to the bead area cords of the tire
If a tire is damaged but is within the above noted criteria, the tire
must be inspected on a daily basis to insure the damage has
not propagated beyond the allowable criteria.
Tire Replacement
JLG recommends a replacement tire be the same size, ply and
brand as originally installed on the machine. Please refer to the
JLG Parts Manual for the part number of the approved tires for a
particular machine model. If not using a JLG approved replace-
ment tire, we recommend that replacement tires have the follow-
ing characteristics:
• Equal or greater ply/load rating and size of original
• Tire tread contact width equal or greater than original
• Wheel diameter, width, and offset dimensions equal to
the original
• Approved for the application by the tire manufacturer
(including inflation pressure and maximum tire load)
Unless specifically approved by JLG Industries Inc. do not
replace a foam filled or ballast filled tire assembly with a pneu-
matic tire. When selecting and installing a replacement tire,
ensure that all tires are inflated to the pressure recommended
by JLG. Due to size variations between tire brands, both tires on
the same axle should be the same.
Wheel Replacement
The rims installed on each product model have been designed
for stability requirements which consist of track width, tire pres-
sure, and load capacity. Size changes such as rim width, center
piece location, larger or smaller diameter, etc., without written
factory recommendations, may result in an unsafe condition
regarding stability.