JLG 800A_AJ Operator Manual - Manual (Page 68)

SECTION 4 - MACHINE OPERATION
4-6 – JLG Lift – 3121209
Shutdown Procedure
IF AN ENGINE MALFUNCTION NECESSITATES UNSCHEDULED SHUT-
DOWN, DETERMINE AND CORRECT CAUSE BEFORE RESUMING ANY
OPERATION.
1. Remove all load and allow engine to operate at low
speed setting for 3-5 minutes; this allows for further
reduction of internal engine temperature.
2. Position POWER/EMERGENCY STOP switch to OFF.
3. Turn key of MASTER switch to OFF position.
NOTE: Refer to Engine Manufacturer’s manual for detailed infor-
mation.
4.4 TRAVELING (DRIVING)
(See Figure 4-4.)
DO NOT DRIVE WITH BOOM ABOVE HORIZONTAL EXCEPT ON A
SMOOTH, FIRM AND LEVEL SURFACE.
TO AVOID LOSS OF TRAVEL CONTROL OR “TIP OVER.” DO NOT DRIVE
MACHINE ON GRADES EXCEEDING THOSE SPECIFIED ON THE SERIAL
NUMBER PLATE.
DO NOT DRIVE ON SIDESLOPES WHICH EXCEED 5 DEGREES.
USE EXTREME CAUTION WHEN DRIVING IN REVERSE AND AT ALL
TIMES WHEN THE PLATFORM IS ELEVATED.
BEFORE DRIVING, LOCATE THE BLACK/WHITE ORIENTATION ARROWS
ON BOTH THE CHASSIS AND THE PLATFORM CONTROLS. MOVE THE
DRIVE CONTROLS IN A DIRECTION MATCHING THE DIRECTIONAL
ARROWS.