JLG M600 Operator Manual - Manual (Page 33)

SECTION 3 - MACHINE CONTROLS AND INDICATORS
3121217 – JLG Lift – 3-1
SECTION 3. MACHINE CONTROLS AND INDICATORS
3.1 GENERAL
THE MANUFACTURER HAS NO DIRECT CONTROL OVER MACHINE
APPLICATION AND OPERATION. THE USER AND OPERATOR ARE
RESPONSIBLE FOR CONFORMING WITH GOOD SAFETY PRACTICES.
This section provides the necessary information needed to
understand control functions.
3.2 CONTROLS AND INDICATORS
NOTE: The optional generator engine will automatically shut
down under the following conditions:
Batteries Fully Charged
High Oil Temperature
Low Oil Pressure
Engine Overspeed
Overvoltage
NOTE: The optional generator engine will not start if the batteries
are fully charged or if the Generator Enable switch on the
platform console is not in the on position.
Ground Control Station
(See Figure 3-1., Ground Control Station w/ Function Enable)
DO NOT OPERATE FROM GROUND CONTROL STATION WITH PERSON-
NEL IN THE PLATFORM EXCEPT IN AN EMERGENCY.
PERFORM AS MANY PRE-OPERATIONAL CHECK AND INSPECTIONS
FROM GROUND CONTROLS AS POSSIBLE.
NOTE: When machine is shut down the Platform/Ground Select
switch and Emergency Stop must be positioned to OFF.
NOTE: If equipped, the Function Enable switch must be held
down in order to operate Telescope, Lift, Swing, Jib Lift,
Platform Level Override, and Platform Rotate functions.
1. Power/Emergency Stop
A two-position red mushroom shaped switch furnishes
power to Platform/Ground Select switch when pulled out
(on). When pushed in (off), power is shut off to the Plat-
form/Ground Select switch.