JLG M600 Operator Manual - Manual (Page 81)

SECTION 6 - GENERAL SPECIFICATIONS & OPERATOR MAINTENANCE
3121217 – JLG Lift – 6-1
SECTION 6. GENERAL SPECIFICATIONS & OPERATOR MAINTENANCE
6.1 INTRODUCTION
This section of the manual provides additional necessary
information to the operator for proper operation and mainte-
nance of this machine.
The maintenance portion of this section is intended as infor-
mation to assist the machine operator to perform daily main-
tenance tasks only, and does not replace the more thorough
Preventive Maintenance and Inspection Schedule included
in the Service and Maintenance Manual.
Other Publications Available:
Service and Maintenance Manual- ANSI, CSA......... 3121117
Service and Maintenance Manual - CE ................... 3121813
Illustrated Parts Manual - ANSI, CSA........................ 3121118
Illustrated Parts Manual - CE .................................... 3121814
6.2 OPERATING SPECIFICATIONS
Table 6-1. Operating Specifications - Prior to S/N 0300141450
Maximum Work Load (Capacity)
Unrestricted:
500 lb (230 kg)
Maximum Travel Grade (Gradeability)
with Boom retracted and approximately
horizontal. Tower Boom fully lowered. 30%
Maximum Travel Grade (Side Slope) with
Boom retracted and approximately hori-
zontal. Tower Boom fully lowered.
5°
Tilt Alarm Setting (See Section 3)
ANSI, CSA
CE E/M600 & E/M600J
CE E/M 600JP
5°
4°
3°
Maximum Vertical Platform Height: 60 ft. (18.29 m)
Maximum Horizontal Platform Reach
E600
E600J
43 ft. (13.11 m)
42 ft. 9 in. (13.11 m)
Machine Width
2WD
4WD
7 ft. 11 7/16 in. (2.42 m)
7 ft. 11 3/8 in. (2.42 m)