JLG M600 Operator Manual - Manual (Page 32)

SECTION 2 - USER RESPONSIBILITIES, MACHINE PREPARATION, AND INSPECTION
2-12 – JLG Lift – 3121217
20. Oscillating Axle and Lockout Valve (If Equipped) -
Check the lockout valve plunger in the depressed
position. Swing the turntable until the axle lockout
bracket passes the plunger and make sure the
plunger is fully extended as shown below
21. Battery Compartment - See Note
22. Fuel Supply - Fuel filler cap secure; Tank - Decals
secure and legible.
23. Hydraulic Oil Filter Housing - See Note
24. Battery Charger - See Note
25. Turntable Bearing - Evidence of proper lubrication. No
loose bolts or looseness between bearing and struc-
ture.
26. Swing Motor - Evidence of proper lubrication.
27. Platform Pivot Pins - See Note
28. Platform Gate - Latch and Hinges in working condi-
tion.
Figure 2-7. Daily Walk-Around Inspection - Sheet 4 of 4