JLG M600 Operator Manual - Manual (Page 36)

SECTION 3 - MACHINE CONTROLS AND INDICATORS
3-4 – JLG Lift – 3121217
2. Platform/Ground Select
A three position, key operated switch supplies power to
the platform control console when positioned to PLAT-
FORM. With the switch key held in the GROUND posi-
tion, power is shut off to platform and only ground
controls are operable.
NOTE: With PLATFORM/GROUND SELECT switch in the center
position, power is shut off to controls at both operating
stations.
3. Rotate
A three position switch permits rotation of the platform.
ONLY USE THE PLATFORM LEVELING OVERRIDE FUNCTION FOR
SLIGHT LEVELING OF THE PLATFORM. INCORRECT USE COULD CAUSE
THE LOAD/OCCUPANT TO SHIFT OR FALL. FAILURE TO DO SO COULD
RESULT IN DEATH OR SERIOUS INJURY.
4. Platform Leveling Override
A three position switch allows the operator to adjust the
automatic self leveling system. This switch is used to
adjust platform level in situations such as ascending/
descending a grade.
5. Boom Lift
Provides for raising and lowering of the Boom.
6. Telescope
Provides for extension and retraction of the Boom.
7. Swing
This switch provides 400 degrees non-continuous turn-
table rotation. To activate SWING, position switch to
LEFT or RIGHT.