JLG M600 Operator Manual - Manual (Page 42)

SECTION 3 - MACHINE CONTROLS AND INDICATORS
3-10 – JLG Lift – 3121217
11. Posi-Track Control
Activating the Posi-Track switch distributes available
power evenly between the two drive wheels for
improved traction. The control system may also engage
the posi-track function automatically when more traction
is required.
NOTE: The optional 4 Wheel Assist will also engage with the
Posi-Track Control.
ONLY USE THE PLATFORM LEVELING OVERRIDE FUNCTION FOR
SLIGHT LEVELING OF THE PLATFORM. INCORRECT USE COULD CAUSE
THE LOAD/OCCUPANT TO SHIFT OR FALL. FAILURE TO DO SO COULD
RESULT IN DEATH OR SERIOUS INJURY.
12. Platform Leveling Override
A three position switch allows the operator to adjust the
automatic self leveling system. This switch is used to
adjust platform level in situations such as ascending/
descending a grade.
13. Horn
If pressed, this switch supplies power to the horn.
14. Drive Orientation Override
When the boom is swung over the rear tires or further in
either direction, the Drive Orientation indicator will illumi-
nate when the drive function is selected. Push and
release the switch, and within 3 seconds move the
Drive/Steer control to activate drive or steer. Before driv-
ing, locate the black/white orientation arrows on both
the chassis and the platform controls and match the
control direction arrow to the intended chassis direction.
15. Soft Touch Override Switch (If equipped)
This switch enables the functions that were cut out by
the Soft Touch system to operate again at creep speed,
allowing the operator to move the platform away from
the obstacle that caused the shutdown situation.