JLG M600 Operator Manual - Manual (Page 38)

SECTION 3 - MACHINE CONTROLS AND INDICATORS
3-6 – JLG Lift – 3121217
Platform Control Station
(See Figure 3-1., Platform Control Station)
1. Power/Emergency Stop
A two-position red mushroom shaped switch furnishes
power to PLATFORM Controls when pulled out (on).
When pushed in (off), power is shut off to the platform
functions.
Within about 2 seconds of pulling the switch out, the
machine will perform a diagnostic check of the various
electrical circuits, and if everything is OK, the platform
alarm will beep once. During this time the lights on the
indicator panel will also blink once as a bulb check.
TO AVOID SERIOUS INJURY, DO NOT OPERATE MACHINE IF ANY CON-
TROL LEVERS OR TOGGLE SWITCHES CONTROLLING PLATFORM
MOVEMENT DO NOT RETURN TO THE OFF OR NEUTRAL POSITION
WHEN RELEASED.
2. Generator Enable Control (if equipped)
This switch allows the operator to prevent the generator
engine from starting to charge the batteries when using
the machine indoors.
3. Lights (If Equipped)
This switch operates accessory light packages if the
machine is so equipped.
4. Drive/Steer
The DRIVE joystick provides for driving either forward or
backward. The controller is ‘ramped’ to allow variable
drive speed.
Steering is controlled by a thumb operated switch on
top of the joystick.