JLG M600 Operator Manual - Manual (Page 54)

SECTION 4 - MACHINE OPERATION
4-8 – JLG Lift – 3121217
Swinging the Boom
To swing boom, use SWING control switch to select RIGHT
or LEFT direction.
WHEN SWINGING THE BOOM MAKE SURE THERE IS AMPLE ROOM FOR
THE BOOM TO CLEAR SURROUNDING WALLS, PARTITIONS AND EQUIP-
MENT.
Raising and Lowering the Upper Boom
To raise or lower the Upper Boom, use Upper Boom Lift
switch to select UP or DOWN movement.
4.8 GENERATOR (OPTIONAL)
Automatic Operating Mode
The generator will operate in automatic mode when:
1. Ground Control EMS is pulled out (on), and:
2. The Generator Enable switch on the platform control
console is in the On or Enable position.
When the above conditions apply, the generator’s controller
will monitor status of the batteries, will turn on automatically
when the battery voltage drops as a result of discharge and
will turn off when batteries are fully charged.
Battery Only Operating Mode
The machine will operate in the battery only mode when:
1. Ground Control EMS is pulled out, and:
2. The switch on the platform control console is in the Off
or Disable position.
The batteries can be used until they are fully discharged.
Manual (Charge) Operating Mode
The generator will operate in manual mode when:
1. Ground Control EMS is pulled out, and:
2. The switch on the platform control console is in the On
or Enable position and:
3. The Manual Charge push button is activated.
Activation of the Manual Charge button will start the engine
and begin the charging cycle even if the batteries are
charged above the level of automatic start.