JLG E300 Service Manual - Manual (Page 161)

SECTION 7 - BASIC ELECTRICAL INFORMATION & SCHEMATICS
3120772 – JLG Lift – 7-9
HD30/HDP20 Series Assembly
1. Grasp contact about 25mm behind the contact
crimp barrel.
2. Hold connector with rear grommet facing you.
3. Push contact straight into connector grommet until a
positive stop is felt. A slight tug will confirm that it is
properly locked in place.
NOTE: For unused wire cavities, insert sealing plugs for full
environmental sealing
HD30/HDP20 Series Disassembly
1. With rear insert toward you, snap appropriate size
extractor tool over the wire of contact to be
removed.
2. Slide tool along into the insert cavity until it engages
contact and resistance is felt.
3. Pull contact-wire assembly out of connector.
NOTE: Do Not twist or insert tool at an angle.
Figure 7-14. HD/HDP Contact Installation
A B
C
Figure 7-15. HD/HDP Locking Contacts Into Position
Figure 7-16. HD/HDP Contact Removal
A B
C
Figure 7-17. HD/HDP Unlocking Contacts