JLG 4017RS Service Manual - Manual (Page 116)

Engine
7-2 3614RS, 4017RS
7.1 INTRODUCTION
7.1.1 Disclaimer and Scope
These instructions are written for worldwide use. In
territories where legal requirements govern engine smoke
emission, noise, safety factors, etc., apply all instructions,
data and dimensions provided herein in such a way that after
maintenance, service and repair of the engine, engine
operation does not violate local regulations.
Note: Detailed engine service instructions (covering
disassembly, inspection, internal repair, assembly, adjustment
and troubleshooting information) are provided in appropriate
engine service manual. A gradual running-in (break-in) of a
new engine is not necessary. Full load can be applied to a new
engine as soon as the engine is put into service and the coolant
temperature is at least 60° C (140° F). Extended light-load
operation during the early life of the engine is not
recommended. DO NOT run the engine at high, no-load
speeds. DO NOT apply an overload to the engine.
7.2 ENGINE SERIAL NUMBER
The engine serial number is stamped on the engine block,
above the oil filter. Information contained in the serial
number is required in correspondence with the engine
manufacturer.
7.3 SPECIFICATIONS AND MAINTENANCE
INFORMATION
For engine, coolant and oil specifications, and maintenance
information, refer to Section 2, “General Information and
Specifications.”