JLG 4017RS Service Manual - Manual (Page 126)

Engine
7-12 3614RS, 4017RS
7.8 AIR CLEANER ASSEMBLY
Note: Refer to the appropriate machine Operation & Safety
Manual for the correct element change procedure.
7.8.1 Air Cleaner Assembly Removal
1. Park machine on a firm, level surface, level machine, fully
retract boom, lower boom, place transmission in (N)
NEUTRAL, engage parking brake, and shut engine OFF.
2. Place a Do Not Operate Tag on both ignition key switch
and steering wheel.
3. Open engine cover. Allow system fluids to cool.
4. Properly disconnect battery.
.
5. Loosen and remove clamp (12) securing air intake tube
(13) to air cleaner (14). Pull air intake elbow off air
cleaner.
6. Remove bolts (15) securing air cleaner straps (16) to air
cleaner (14). Remove air cleaner assembly.
7.8.2 Air Cleaner Assembly Installation
1. Install the air cleaner assembly (14) to the air cleaner
mounting plate and secure with the previously used
hardware.
2. Place the loosened clamp (12) over the air intake elbow
(13) and install elbow on the air cleaner assembly.
Tighten clamp.
3. Properly connect battery.
4. Close and secure engine cover.
5. Remove Do Not Operate Tag from ignition key switch
and steering wheel.
NOTICE
NEVER run the engine with only the inner safety element
installed.
M 7510 Z
15
14
13
12
16