JLG Workstation in the Sky-Scissor Lifts - Manual (Page 17)

SECTION 1 - ES SCISSOR ACCESSORIES
3128160 – JLG Lift – 1-9
1.5 PANEL CARRIER
Description
The Panel Carrier is designed to be loaded with sheet
material up to 4ft x 8ft (1.2m x 2.4m) in size (See panel
carrier decal for weight capacity). It consists of a tray that
runs parallel to the length of the platform and an adjust-
able device mounted to the handrail to hold the material in
place until needed.
Safety Precautions
NOTE: When Workstation is installed, Pipe Racks and
Panel Carrier cannot be installed on the same
machine.
MULTIPLE MATERIAL HANDLING ACCESSORIES CAN BE
INSTALLED, BUT ONLY ONE MAY BE UTILIZED (LOADED) AT A
TIME, UNLESS APPROVED BY JLG INDUSTRIES, INC.
WITH THE PANEL CARRIER INSTALLED, THE ORIGINAL PLAT-
FORM CAPACITY RATINGS MAY BE REDUCED. REFER TO THE
CAPACITY DECAL LOCATED ON PANEL CARRIER.
AN INCREASE OF THE AREA EXPOSED TO THE WIND WILL
DECREASE STABILITY. REFER TO PANEL CARRIER DECAL FOR
MAXIMUM PANEL SIZE AND MAXIMUM WIND SPEED.
Preparation and Inspection
• Check for cracked welds and damage to tray.
Make sure tray is properly secured to platform.
• Check to ensure that strap is not torn or frayed.
• Only use the panel carrier option on models
specified.
• Remove tray when not in use.
• Check for missing or illegible decals.
Operation
1. Load the panel carrier with panel and secure with a
strap.
2. Position panel to its desired location.
Service and Maintenance
• Replace torn or frayed straps, bent or crushed
tray, missing or illegible decals.
• Check for loose nuts and bolts and torque loose
nuts or bolts to JLG torque chart specifications.
BAIL
PIN
Figure 1-11. Panel Carrier