2N StarGate/BlueTower v5.5 User Manual
Page 86
86
Prefix List 1–8
Eight prefix groups to be assigned in the LCR table.
Basic Settings
GSM network ID – set the prefix list user code for easier orientation in the LCR.
Default count of digits – default length of the number to be dialled into the
GSM/UMTS networks for routing via the selected prefix list. Use this parameter in
case the Digits count is not included in the Accepted prefixes table.
Table of Replaced Prefixes
Use this table to replace the prefix of the received number (‘00’ with ‘+’, e.g.). You can
only add or remove the prefix. This change is made before the prefix is searched for in
the prefix table. Be sure to keep the „/“ record in the table for a proper function.
Table of Accepted Prefixes
List of prefixes of called destinations to which the selected prefix list applies.
Prefix Change for PRI 1 to PRI 2 Calls
A table of prefixes to be replaced in the case of PRI 1 to PRI 2 outgoing calls.
Note
The number to be dialled to the GSM/UMTS network must meet the
condition.
Count of digits
For
calls, the count of digits to be dialled must be equal to or higher
VoIP
than the value set in the
.
Count of digits
For GSM/UMTS calls by overlap dialling via the
interface, the
PRI NT/TE
defines the maximum count of the digits to be dialled.
Count of digits
For GSM/UMTS calls by block dialling via the
interface, the
PRI NT/TE
is ignored.
Count of digits
Note
The maximum count of records in the
is 14
Table of replaced prefixes
for each prefixlist.
The maximum table record size is 9 characters for the prefix and 9
characters for the replaced number.
Note
The maximum count of records in the
is 138
Table of accepted prefixes
for each prefixlist.
The maximum table record size is 9 characters.