2N StarGate/BlueTower v5.5 - Manual (Page 87)

87
2N TELEKOMUNIKACE a.s., www.2n.cz
®
LCR Table
Table of outgoing Least Cost Routing (LCR) rules. Every outgoing call from the PRI
1/VoIP interface is routed to GSM / UMTS according to this table. For a call, the
gateway checks the lines and if the called number prefix matches the prefix in the
selected network list and the current time value is within time limitation limits, the call
will be routed via the defined GSM group(s) or PRI 2 interface.
Prefix list – prefixes to be used for a selected LCR row.
Time limitation – time validity limitation for a selected LCR row.
Weekend usage – enable/disable a row on weekends.
i Call duration lim – set the maximum duration (minutes) for an outgoing call to
the GSM/UMTS network.
Groups – outgoing GSM groups used for the selected LCR row.
Fallback port (9): set the fallback port. If the fallback port service is
unavailable, the next LCR table row is applied. Select the appropriate
routing rule to set the fallback port in the Gateway configuration Port
. modes
Tariffs – select the tariff group (free minute counter) to be used for the outgoing
call. Refer to the GSM outgoing groups subsection for details.
Ignore tone detection in last group – having detected a user defined tone
(refer to GSM basic settings), the GSM gateway automatically terminates the call
and seeks for another call setup way. If this parameter is activated, the GSM
gateway ignores the tone detection results and sets up a call when this is the
only possible call establishing way.
CLIP Routing Table + CallBack
Use the table to set a fixed CLIP assignment of incoming CLIPs from GSM to the
numbers of extensions to which incoming calls are routed automatically. Also, set the
CLIP list in the GSM network for which CallBack is enabled.
GSM number (CLIP) – user Id in GSM/UMTS.
Used Service
Autodial – enable/disable CLIP routing for the selected CLIP.
Reject call – reject call for the selected CLIP.
Ignore call – ignore call for the selected CLIP
Tone dial–in – incoming GSM calls is accepted + dialtone is activated for
the selected CLIP
Disa message dial–in – incoming GSM calls is accepted + voice
message is activated for the selected CLIP
Dial to VoIP – VoIP destination number for the CLIP routing function.
Auto CallBack – enable/disable CallBack routing for the selected CLIP.
Call duration limit – set the maximum call duration (minutes).
Note
If you use tariff routing, set the tariffs properly in the GSM outgoing
groups subsection
The maximum count of LCR table records is 64.