Gsm basic parameters – 2N BRI Lite/Enterprise v1.4 User Manual
Page 61
61
Still activated ISDN layer 1
– enable/disable keeping of ISDN layer 1 active.
Still activated ISDN layer 2 (SABME/UA)
– enable/disable keeping of ISDN
layer 2 active.
Send SMS at state changes – enable/disable alert sending upon BRI1 state
change.
BRI common settings
Timeout for ISDN line deactivation detection [s]
– an SMS alert
on BRI1/BRI2 deactivation is sent after this timemout.
Timeout for ISDN line activation detection [s]
– an SMS alert on BRI1/BRI2
activation is sent after this timemout.
Numbers where SMS will be sent to
– list of numbers to which the SMS alert
shall be sent.
Text of SMS
– SMS alert text with the following parameters:
%P(x|y), where "x" represents any text concerning BRI1 and "y"
represents any text concerning BRI2.
%A(x|y), where "x" represents any text for interface deactivation and "y"
represents any text for interface activation.
Settings of Alive SMS interval
Send Alive SMS – enable/disable sending of ALIVE SMS.
Time [hh:mm] – ALIVE SMS sending time.
Days interval – ALIVE SMS sending interval.
Numbers where SMS will be sent to – list of numbers to which the ALIVE SMS
shall be sent.
Text of SMS – ALIVE SMS text.
GSM Basic Parameters
Number of digits dialled from VoIP
Minimum numbers from VoIP – set the minimum count of digits to be dialled into
the GSM network.
Maximum numbers from VoIP – set the maximum count of digits to be dialled
into the GSM network.
Wait for next digit [s] – set the timeout for
gateway to wait for the
2N BRI
®
next digit dialled from VoIP to GSM.
Calls
Relax timeout [s] – set the timeout between the end of the last call and
beginning of the next call made via one and the same GSM module (incoming
and outgoing calls are rejected during this timeout). The recommended relax
value is 2 seconds – please do not change this setting unless absolutely
necessary.
Timeout for ringing to GSM [s] –
ringing timeout for outgoing calls to GSM. If not
answered or terminated within this timeout, the call will be terminated
automatically by the gateway when this timeout elapses.