2N Lift8 v1.5.2 User Manual
Page 170
170
Figure:
Incoming Call Pop-Up Window
See the figure below for the Incoming call window. The upper part displays the
currently speaking lift name and phone number and one of the following Application
states to the right:
... – the selected outgoing/incoming call is just ringing.
Ringing
... – the call was answered by both the subscribers and is in progress.
Speaking
– the call was terminated correctly.
Call terminated
– the outgoing call was rejected by the counterparty.
Call rejected
– the incoming call was not served. Ringing stopped before the
Missed call
dispatcher answered the call.
The left-hand part of the screen provides information on the given lift: Name, Lift
identification, Contact number and Address. Use the keypad below these items to
control the Speaking call: confirm the call with DTMF or dial the required shaft number.
A calling technician can use the keypad for the
voice menu control. Press a button
CU
to send the particular DTMF character into the call. If the lift address is completed, the
lift location is displayed on the map below the keypad. Use the slider in the left-hand
upper corner to zoom in/out.
Tip
No matter where you pick up the call (whether in the application or the
pop-up window), the system always behaves identically.