2N Lift8 v1.5.2 - Manual (Page 81)

81
2N TELEKOMUNIKACE a.s., www.2n.cz
®
1.
2.
3.
4.
5.
4.2 Control Centre Instructions
ALARM Call
Press the ALARM button on any Audio Unit to make call the control centre L8
(refer to Automatic Dialling for details).
A received call is either confirmed as configured (parameters 111–116 >
Confirmation mode for memory 1–6 ALARM call – set 1). By default,
is set in . confirmation of DTMF 1 L8
If the control centre is equipped with the , you Communicator 2N
®
application
can configure automatic sending of DTMF 1 after call pick-up.
The call is time limited (press button 4 upon warning announcement “Caution,
the call is ending” to extend the call).
You are recommended to end the by pressing 5 or #.
Control Room-to-Lift Calling
The control centre can also call back to the communicator. The automatically CU
receives every incoming call, identifies itself and, via a voice menu (DISA), offers you
another function to get through to the required Audio Unit. Incoming calls are time
limited as outgoing calls and are processed in the same way (extension, termination).
Incoming Call Voice Menu
Welcome, this is a Lift 8 communicator 2N
®
Press 0 for connection with the last-calling Audio Unit
Enter the lift number X to dial another Audio Unit
Press 1 to dial the lift cabin
Press 2 to dial the cabin roof
Press 3 to dial the lift bottom
Press 4 to dial the shaft bottom
Press 5 to dial the machine room
Press # to return to the main menu
Press 9 for administration
Press 1 to enter the programming menu
Press 2 to terminate the rescue process
Press 3 to listen to your communicator info
Press # to return to the main menu
o end the call Press # t
The menu above makes it possible to call the selected Audio Unit.
Caution
Press # to go one level back in the voice menu.
You can also terminate a call using #, but only on the highest voice menu
level: Press 0 for connection with the last-calling Audio Unit, Enter the lift
number X for connection with another Audio Unit, Press 9 for
administration, information or rescue process, and Press # to end the call.