2 splitter, Description – 2N Lift8 v1.5.2 User Manual
Page 34
34
2.2 Splitter
Description
The splitter helps connect the
with the lift Audio Units. It is connected with the
CU
CU
via six wires (power, audio, data). The Audio Units (audio units) are connected to the
splitter using a two-wire bus. The splitter also contains a make/break contact for the
lift blocking function. There can be up to 7 splitters (according to the count of lift
shafts).
Each splitter must be configured for a different address (lift shaft number) for the
system to work. The addresses are 2–8 (lift 2–8). Lift 1 is the
.
CU
The splitters are connected in series, i.e. one after another (never in parallel), to avoid
system instability. A termination resistor (jumper) is mounted on the last splitter
.
(furthest from the
)
CU
Splitter
Figure: 2N Lift8
®
Caution
Local power supply is not supported yet.