2N StarGate/BlueTower v5.4 - Manual (Page 171)

171
2N TELEKOMUNIKACE a.s., www.2n.cz
®
5.3 Tracing
2N StarGate / BlueTower
®
allows for operation tracing (VoIP, SIP, GSM). Tracing is
accessible in one session only at a time, the other tracing requests are rejected with
BUSY. With regard to a rather extensive volume of data, we recommend that the Write
communication into file function should be activated before tracing. Any
Telnet-supporting terminal (HyperTerminal, Putty, etc.) can be used.
Tip
You are advised to synchronise your GSM gateway with the SIP
Proxy, or a PC before tracing.
AT
Command
Description
AT%S92=x
Description AT%S92=x Set the tracing details. Refer to the table below
for value X.
AT!R2 Start tracing via the active session.
Any
character
Terminate tracing.
Layer 3 and 4
Status Listing Timestamp
Write-Out SMP Packet
Write-Out Layer 2 Status
Listing LCR
Listing
1 2 4 8 16
The resultant value X is a sum of the required functions (X= timestamps+LCR = 16+2
= 18, e.g.).