2N StarGate/BlueTower v5.4 - Manual (Page 58)

58
2N TELEKOMUNIKACE a.s., www.2n.cz
®
Main Installation
Place the gateway into an environment that complies with the gateway working
conditions.
Configure the gateway properly using the configuration software included.
The gateway mains supply must be backed–up and overvoltage–protected (a
line–interactive or on–line UPS is recommended).
Any of the available remote control tools (ISDN line, analogue line, Ethernet) are
advised for a more comfortable gateway administration.
Control Ways
The system can be supervised and controlled locally or remotely as follows:
Local control using a PC connected by a standard full crossed serial cable.
Remote connection over the IP network using the Telnet protocol or web
interface.
Remote connection over a data call to the ISDN PRI interface
(not supported at
). present
Configuration Ways
The system can be configured by any of the following ways:
Using extended AT commands (refer to the subsection). 4. List of AT Commands
Using the CPU web interface.