Users – 2N StarGate/BlueTower v5.4 User Manual
Page 97
97
Caution
The count of user accounts is file-licensed. Refer to
for the current GSM gateway
Management–>Licence key
licence details.
Users
This section helps you manage the SMS users. Select a communication protocol for
user adding (SMTP/POP3 or SMPP).
Add user
User group –
assign the user to a User group.
User full name –
define the system user name.
Replace dial for outgoing SMS –
define the number (CPN) to which the user's
outgoing SMS messages shall be sent.
Access type –
select the communication protocol for SMS processing:
Login name (without domain) – define the login name for the client Email.
Email (SMTP/POP3)
– use SMTP for SMS sending and POP3 for SMS
receiving.
SMPP (SMSC)
– set the GSM gateway into the 'SMS centre' mode.
SMPP (ESME) – set the GSM gateway into the 'ESME - External Short
Messaging Entity' mode.
System ID –
SMSC user
ID.
Password –
SMSC/SMTP user password.
System ID (for authentication on remote side) –
ESME user ID.
Password (for authentication on remote side) –
ESME user ID.
set the TCP parameter into the client/server mode.
TCP type –
Server address –
set the server IP address and
TCP server transport port.
Message direction of Esme – set the ESME user details:
Transceiver –
ESME works as a transmitter/receiver.
Transmitter
–
ESME works as a transmitter.
Receiver
–
ESME works as a receiver.
Address range
–
set this parameter if required so by SMSC for SMS receiving.
Delivery status required – set the SMS sending request for outgoing SMS
delivery confirmation
.
Send message as Flash SMS
– activate the Flash SMS function for outgoing
SMS messages.
Note
You can set the
parameter only if the
Delivery status required
SMTP/POP3 protocol is used.
With SMPP, the delivery information is active automatically in
case the service is required by the SMPP counterparty or via an
incoming SMS message from the GSM/UMTS network.