2N StarGate/BlueTower v5.2 User Manual
Page 36
36
operation means only swapping of the transmitting and receiving connector pairs, the
interface configuration must be made using the configuration tool. With jumper JP4 you
can activate/deactivate the back–up connection between PRI 1 and PRI 2 in case the
system is switched off or the PRI board is not handled by system.
Warning
The back–up connection (JP4) works only in case the wire
settings of PRI 1 (JP3) and PRI 2 (JP2) are set in the opposite
way (e.g. PRI 1 as NT, PRI 2 as TE).
Note
Boards with just one PRI interface (1PRI boards) have the same
settings as the PRI 1 interface on 2PRI boards. And there is no
back–up connection (JP4) either.
Positions of Tx and Rx Wires
Example of Connection with 1ISDN PRI Board