2N StarGate/BlueTower v5.2 - Manual (Page 87)

87
2N TELEKOMUNIKACE a.s., www.2n.cz
®
Used Service
Autodial – enable/disable CLIP routing for the selected CLIP.
Reject call – reject call for the selected CLIP.
Ignore call – ignore call for the selected CLIP
Tone dial–in – incoming GSM calls is accepted + dialtone is activated for
the selected CLIP
Disa message dial–in – incoming GSM calls is accepted + voice
message is activated for the selected CLIP
Dial to VoIP – VoIP destination number for the CLIP routing function.
Auto CallBack – enable/disable CallBack routing for the selected CLIP.
Call duration limit – set the maximum call duration (minutes).
Note
Remember to activate the CallBack mode in the GSM incoming
for a proper function. groups
Ethernet Configuration
This window helps you configure the Ethernet interface of your gateway.
Use DHCP – enable/disable the DHCP client function in 2N StarGate /
®
. BlueTower
IP address – the fixed IP address (v4) of the 2N StarGate / BlueTower
®
Ethernet interface.
Subnet mask – the subnet mask for the Ethernet 2N StarGate / BlueTower
®
interface.
Default gateway – The IP gateway IP address (v4) in the Ethernet network.
Caution
Incorrect settings, e.g. enabling the , may DHCP client service
result in a denial of access to the 2N StarGate / BlueTower
®
configuration. To avoid this, restore the GSM gateway default
settings.
Refer to Subs. for details Jumper pro Basic CPU Board
default.
Tip
In case the gateway is in the DHCP client mode, current
assignments obtained from the DHCP server are displayed in the
and Default gateway items. IP address, Subnet mask
Login Configuration
The window helps you set the access password and name for the 2N StarGate /
®
web interface. Use the same data for Telnet connection too. BlueTower
Caution
Remember to change the username and password during the
first gateway configuration to avoid unauthorised access!