ADS-TEC IWL3000 User Manual - Manual (Page 23)

IWL3000 series 22
© ads-tec GmbH • Raiffeisenstr.14 • 70771 Leinfelden-Echterdingen
6.2 Manual configuration of the network adapter
Information:
The procedure described in the following was prepared using the Microsoft
Windows XP professional® operating system as an example. If you are
using another operating system, the paths and properties described here
may vary.
Open the properties map for your network adapter. The relative path is as follows:
Network connections> LAN connection> Properties (right mouse-key).
In the dialogue tab that appears, select option: Internet protocol (TCP/IP) and then click on
Properties.
Fig. 8:
Now select: Use the following IP address
Access to the device is only enabled if the following parameters are entered as the fixed IP address or if
the computer is located in the same subnet space:
IP ADDRESS: 192.168.0.100
Information:
The last set of digits must be a number between 1 and 253. In the example, "100"
has been selected.
Once the IP address has been entered, the subnet mask address must be entered. Click on the
Subnet mask field and the correct address is entered automatically.
Subnet mask: 255.255.255.0
The dialogue tab can now be closed with "OK".