ADS-TEC IWL3000 User Manual - Manual (Page 5)

IWL3000 series 4
© ads-tec GmbH • Raiffeisenstr.14 • 70771 Leinfelden-Echterdingen
1.4 Trademarks
It is noted that any software and/or hardware trademarks and any company brand names as mentioned
in this documentation are all subject to the general trademark, brand name and patent protection rights.
Windows®, Windows® CE are registered trademarks of Microsoft Corp.
Intel®, Pentium®, Atom™ , Core™2 are registered trademarks of Intel Corp.
IBM®, PS/2® and VGA® are registered trademarks of IBM Corp.
CompactFlash® is a registered trademark of the Compact Flash Association.
RITTAL® is a registered trademark of the Rittal Werk Rudolf Loh GmbH & Co. KG.
Any other additional trademarks and/or brand names herein, be they domestic or international, are
hereby duly acknowledged.
1.5 Copyright
This manual including all images contained herein is subject to copyright. Third-party use of this manual
that infringes on the copyright terms is forbidden. Reproduction, translation, or electronic and
photographic archiving or alteration requires the express written consent of ads-tec GmbH.
Infringements or violations shall result in an obligation to provide compensation for damages.
1.6 Standards
This device is compliant with the provisions and safety objectives of the following EU directives:
Standards

This device is compliant with the CE mark test requirements as defined in the
European test standards EN 55022 and EN 50082-2

This device is compliant with the DIN EN 60950 (VDE0805, IEC950) testing
specifications on “Information technology equipment – Safety"

This device is compliant with the DIN EN 60068-2-6 testing specifications
(sinusoidal vibration)

The device is compliant with the DIN EN 60068-2-27 testing specifications
(shock resistance test)
Information:
A corresponding declaration of conformity is available for competent authorities at
the manufacturer and can be viewed upon request.
For full compliance with the EMC legislation, all components and cables used for
device connection must also be compliant with these requirements. It is therefore
necessary to employ BUS and LAN cables with shielded connectors and these
must be installed as per the instructions contained in the user manual.