ADS-TEC IWL3000 User Manual - Manual (Page 6)

IWL3000 series 5
© ads-tec GmbH • Raiffeisenstr.14 • 70771 Leinfelden-Echterdingen
2 Operating and safety instructions
The device operates under electrical voltage and contains highly sensitive components. Intervention by
the user is required only for connecting the power supply lines. Should any further modifications be
required, it is necessary to consult either with the manufacturer directly or with service personnel
authorised by the manufacturer. The device must be de-energised during work. Appropriate measures
must be taken to prevent electrostatic discharges on components. If the device is opened up by an
unauthorised person, the user may be subject to hazards and the warranty is invalidated.
Information:
Only the original ads-tec firmware / software is allowed for any of the settings and
features described in this manual. Loading of any firmware / software that has not
been released by ads-tec invalidates the warranty.
Mounting, placing into operation and operation must only be conducted by
appropriately qualified and trained personnel
All persons who use the device must strictly observe all safety instructions and the
manual
All rules and regulations on accident prevention and safety applicable at the device
installation site must be observed
This manual provides the most important information for safe operation of the
device
Safe and proper device operation requires proper storage, proper transport and
handling, setup, commissioning and careful operation
2.1 Safety instructions
Caution:
To prevent damage to the device, all cable lines (power supply, interface cables)
must be only be connected while the device is switched off.
Caution:
All installation work performed on the device must be performed only under safe,
secure and de-energised conditions.
Warning of hot surface
When handling the equipment with ambient temperatures of 50 ° C or more
mandatory protective gloves must be worn.
Failure to observe this warning may result in burns or damage to property.
Information:
Always adhere to the safety measures applicable when handling components at
risk of being damaged by electrostatic discharges.
(DIN EN 61340-5-1 / DIN EN 61340-5-2)