ADS-TEC IWL3000 User Manual - Manual (Page 7)

IWL3000 series 6
© ads-tec GmbH • Raiffeisenstr.14 • 70771 Leinfelden-Echterdingen
2.2 Operating location
This device is designed for industrial use. Make certain that the specified environmental conditions are
maintained at all times. Use in non-specified environments, i.e., on board ships, in explosive
atmospheres or at extreme elevations, is prohibited.
Caution:
To prevent the formation of water condensate, the device may be turned on only
after it has reached the specified ambient temperature. This also applies if the
device is exposed to extreme temperature fluctuations.
Avoid overheating during operation: the device must not be exposed to direct
sunlight or to any other direct light or heat sources.
Caution:
This is a class A device. Class A devices may cause interference when used
in residential environments. In this case, the operator may be required to
take appropriate measures.
2.3 Damage due to improper use
Should the control system have evident signs of damages caused, e.g., by improper operation or
storage conditions or due to improper use or handling, the device must be shut down immediately.
Ensure that it is secured against being started up accidentally.
2.4 Warranty / repairs
During the device warranty period, any repairs must only be performed by the manufacturer or by
service personnel that has been authorised by the manufacturer.