AirLive WFP-151U - Manual (Page 47)

5. Server Configuration
AirLive WFP-151U User’s Manual 42
wireless connection. It makes the configuration much easier without creating the wireless
connection in advance.
Note: After you have set the wireless function, please remove the Ethernet cable and then
re-plug the power jack of the MFP Server to activate the wireless connection.
Enable – Enable wireless function only, the MFP Server’s wireless LAN will be always
enabled and Ethernet will be always disabled.
Disable – Disable the wireless function, the MFP Server’s wireless LAN will be always
disabled and Ethernet will be always enabled.
Domain Country: The wireless channels are different from country to country. Generally,
the channels are from 1 to 11 in USA and from 1 to 13 in Europe. The operating channel will
be set to the MFP Server before importing. If you are in different country, please make sure
that you have set the available channels according to your location.
5.8 Wireless Configuration
If you want to use the MFP Server through wireless LAN, please set up the MFP Server
through Ethernet first and make sure your wireless LAN setting is correct. After setting the
wireless LAN, unplug the Ethernet cable and restart the MFP Server, then you can start to
use the MFP Server through wireless LAN. If the wireless configuration does not work,
please plug the Ethernet cable again, restart the MFP Server and configure the MFP Server
through Ethernet until the wireless LAN settings are correct.
The default settings of the MFP Server wireless function are as follows.
Mode: Ad Hoc; SSID: Default; Channel: 11