AirLive WFP-151U - Manual (Page 48)

5. Server Configuration
43
AirLive WFP-151U User’s Manual
Double Click “Wireless” icon and the wireless configuration window will pop-up. If you use
access point to build up wireless network, you have to select “Infrastructure Mode”. If you
do not have any access point and want to use peer-to-peer connection to build up wireless
network, you have to select “Ad-Hoc Mode”.
For Wireless Function, you can select “Auto”, Enable” or “Disable” to manually configure
the wireless function.
Auto – “Auto” is the default setting of the MFP Server. At this mode, the MFP Server will
automatically decide to enable or disable the wireless function. When the MFP Server
starts up, it will auto-detect if the LAN port is connected to an active network by an Ethernet
cable. If this is the case, the MFP Server will run in Ethernet mode. If the MFP Server is not
connected to an active network by Ethernet cable, the MFP Server will run in wireless LAN
mode.
Users can plug the Ethernet cable to the MFP Server at the first, after configuring the MFP
Server features and wireless settings; they can unplug the Ethernet cable to enable the
wireless connection. It makes the configuration much easier without creating the wireless
connection in advance.
Note: After you have set the wireless function, please remove the Ethernet cable and then
re-plug the power jack of the MFP Server to activate the wireless connection.
Enable – Enable wireless function only, the MFP Server’s wireless LAN will be always
enabled and Ethernet will be always disabled.
Disable – Disable the wireless function, the MFP Server’s wireless LAN will be always
disabled and Ethernet will be always enabled.
After selecting the operation modes of the wireless function, click “Next” to go to further
detailed configuration.
Infrastructure Mode