AirLive WH-9000MESH - Manual (Page 24)

Chapter 6: Wireless Access Point Configuration
This chapter describes the items about set up AP function. Those items are under the Wireless Access
Point Configuration menu. If you don’t know how to enter configuration screen, chapter 4 describes
how to do it. Please keep in mind that you need click Apply to save all settings.
6.1 Wireless Access Point – General
Click the entry on the left hand navigation panel for Wireless Access Point – General. This directs you
to the Wireless Access Point – General page.
Figure 6-1 Wireless Access Point – General screen
6.1.1 MAC address
The MAC address list here is AP’s wireless interface. This is not the BSSID for bridging setup. The
BSSID for bridging is found on the Wireless Bridge – General page.
6.1.2 SSID
If you will be using an SSID for a wireless LAN, enter it here and in the setup of each wireless client.
This nomenclature has to be set on the AP and each wireless device in order for them to communicate.
6.1.3 Wireless Mode
The wireless Mode menu allows you to specify whether you want AP to operate solely in the 802.11a,
802.11b, 802.11g or in a combination of 802.11b/g. The 802.11b/g use 2.4GHz ISM (Industrial,
Scientific and Medical) frequency band and the 802.11a use the 5GHz UNII (Unlicensed National
Information Infrastructure) frequency band.
AirLive WH-9000-MESH User’s Manual 23