AirLive WH-9000MESH - Manual (Page 32)

6.4 Rogue AP Detection
This function allows the network administrator to
detect in band rogue AP. Enable rogue AP
detection and enter the MAC Address of each
AP in the network that you want the AP being
configured to accept as trusted AP (You may a
up to 20 APs). Enter an email address for
notification of any rogue or non- trusted APs
when WH-9000MESH find it. You can also select
the following filter options.
dd
y SSID Filter: Check the SSID option to only
send rogue APs that match the AP's SSID
or wireless bridge's SSID.
y Channel Filter: Check the channel filter
option to only send rogue APs that match
the AP's channel or the wireless bridge's channel.
y If both options are checked, only APs that match both the SSID and channel are sent.
The Adjacent AP lists under Monitoring/Reports on the navigation menu, will detail any APs’
information.
6.5 Wireless Access Point – Advanced
Click the entry on the left hand navigation panel for Wireless Access Point – Advanced. This directs you
to the Wireless Access Point – Advanced page. The Advanced page allows you to enable or disable
load balancing and Layer 2 Isolation
6.5.1 Load Balancing
Load balancing is enabled by default to distribute traffic efficiently among network servers so that no
individual server is overburdened. For example, if two APs with similar settings are in a conference
room, depending on the location of the APs, all wireless clients could potentially associate with the
AirLive WH-9000-MESH User’s Manual 31