4 point-to-point bridge setup guide – AirLive WH-9000MESH User Manual
Page 38
7.4 Point-to-Point Bridge Setup Guide
A point-to-point link is a direct connection between tow, and only two, locations or nodes. Because the
WH-9000MESH’s bridge function uses a separate WLAN card for bridge. Thus, the 9000MESH can
work AP and Bridge function simultaneously.
Figure 7-1 Point-to-Point Bridge scene
For the two bridges that are to be linked to communicate properly, they have to be set up with
compatible commands in setup screens. Below is the list
y
Channel number:
-
The bridges must have the same channel number.
-
The channel number doesn’t be same as using for AP.
y
Wireless Mode:
-
Choose 802.11g for high data rate
-
Choose 802.11b for high transmit distance
y
Spanning Tree Protocol (802.1d):
-
Enable, if there is any possibility of a bridging loop, or
-
Disable, if there is no possibility of bridging loop to gain higher efficient
y
Bridge signal strength LED port:
-
Set up the SS LED map to which remote bridge
AirLive WH-9000-MESH User’s Manual
37