AirLive WH-9000MESH - Manual (Page 41)

Wireless Bridge - General
Bridge Mode Manual Bridge Manual Bridge
Spanning Tree Protocol
Enable
(or Disable if no bridging loop)
Enable
(or Disable if no bridging loop)
Wireless Bridge - Radio
Channel 4 4
Wireless Mode 802.11g (for high data rate) 802.11g (for high data rate)
TX Power Auto Auto
Propagation distance Select appropriate value Select appropriate value
BSSID
Add Bridge 2 BSSID
(MAC address)
Add Bridge 1 BSSID
(MAC address)
Wireless Bridge – Encryption
Encryption
Select appropriate Key type and
Key. Must be the same key as
Bridge 2 Select appropriate Key type and
Key. Must be the same key as
Bridge 1
The above recommended setup requires only Bridge 1 to be set in point-to-multipoint mode. It is
possible to set all bridges in point-to-multipoint mode, in which case, each bridge would have to contain
the BSSID for each of the other bridges and Spanning Tree Protocol must be enabled.
7.6 Repeater Bridge Setup Guide
A repeater setup can be used to extend the wireless signal from one bridge connected to an Ethernet
LAN wirelessly so that another bridge can control a wireless LAN at a distance. Figure 7-4 illustrates
this topology.
Figure 7-4 Point-to-Multipoint Bridge scene
Table 7-3 describes the basic attributes for the network topology illustrate at Figure 7-4.
Table 7-3 Repeater Configuration table
Direction Bridge 1 Bridge 2 Bridge 3
AirLive WH-9000-MESH User’s Manual 40