AirLive WIAS-1200G - Manual (Page 17)

AirLive WIAS-1200G
User’s Guide
9
3.1.4 Installation Steps
Please follow the following steps to install AirLive WIAS-1200G:
1. Connect the power adapter to the power socket on the rear panel. If the power supply and connection is normal,
the Power LED on the front panel will light up.
2. Connect an Ethernet cable to the WAN Port on the rear panel. Connect the other end of the Ethernet cable to an
ADSL modem, a cable modem or a switch/hub of the internal network. The LED of the WAN on the front panel
should be on to indicate a proper connection.
3. Connect an Ethernet cable to the LAN1/LAN2 Port on the rear panel. Connect the other end of the Ethernet
cable to an AP or a switch. The LED of LAN1/LAN2 should be on to indicate a proper connection. (Note:
Authentication is required for the clients to access the network via the LAN1/LAN2 Port. The LAN port with
authentication required is referred to as Public LAN.)
4. Connect an Ethernet cable to the LAN3/LAN4 Port on the rear panel. Connect the other end of the Ethernet
cable to a networking device such as the administrator’s PC. The LED of LAN3/LAN4 should be on to indicate a
proper connection. (Note: Authentication is NOT required for the clients to access the network via the
LAN3/LAN4 Port. The LAN port without authentication required is referred to as Private LAN.)
After the hardware of AirLive WIAS-1200G is installed completely, the system is ready to be configured in the
following sections. The manual will guide you step by step to set up the system using a single AirLive WIAS-1200G
to manage the network.