AirLive WIAS-1200G User Manual
Page 42
AirLive WIAS-1200G
User’s Guide
34
y
Wireless Configuration
IP PNP:
Use any IP address to connect to the system. Regardless of what the IP address at the users end is,
they can still be authenticated through AirLive WIAS-1200G and access the network.
User Authentication:
If “User Authentication” is disabled, “Specific Route Profile” needs to be specified for
the users to access Internet.
Operation Mode:
Choose one of the two modes, NAT mode and Router mode, by the requirements.
IP Address:
Enter desired IP address for the wireless port.
Subnet Mask:
Enter desired subnet mask for the wireless port.
y
DHCP Server Configuration
There are three methods to set the DHCP server: Disable DHCP Server, Enable DHCP Server and Enable
DHCP Relay
.
1. Disable DHCP Server: Disable the DHCP Server function.
2. Enable DHCP Server: Choose “Enable DHCP Sever” function and set the appropriate configuration for
the DHCP server. The fields with red asterisks are required to be filled in.
DHCP Scope:
Enter the “Start IP Address” and the “End IP Address” of this DHCP block. These fields
define the IP address range that will be assigned to the Wireless LAN clients.
Preferred DNS Server:
The primary DNS server for the DHCP.