AirLive WL-5460AP v2 - Manual (Page 11)

AirLive WL-5460AP v2 User Manual
12
1.3.3 Configuration Setups
The factory default settings of WL-5460AP are as following:
Settings Default Value
Device Name WL-5460AP
Radio 802.11b/g
SSID airlive
Channel 11
WEP Disabled
IP Address 192.168.100.252
DHCP Server Disabled. Available and default enabled when each of
the wireless is configured as a gateway.
DHCP IP Range 192.168.100.100 ~ 192.168.100.200
1.3.4 Hardware Connection
Note: Before you starting hardware connection, you are advised to find an appropriate
location to place the Access Point. Usually, the best place for the Access Point is at the
center of your wireless network, with line of straight to all your wireless stations. Also,
remember to adjust the antenna; usually the higher the antenna is placed; the better will be
the performance.
1. Connect to your local area network: connect an Ethernet cable to one of the Ethernet
port (LAN1 or LAN2) of this Wireless Access Point, and the other end to a hub, switch,
router, or another wireless access point.
2. Power on the device: connect the included AC power adapter to the Wireless Access
Point’s power port and the other end to a wall outlet.