AirLive WL-5460AP v2 User Manual
Page 60
AirLive WL-5460AP v2 User Manual
61
D. Bandwidth Control by MAC address
You can set the maximum bandwidth of a PC or a subscriber by using the MAC Control.
Please follow the procedure below to setup MAC Traffic Control
1. Please make sure the “Interface Traffic Control” is disabled
2. Before you start, please check the following area to see which client MACs are
supported. It differs between each mode.
3. Enable the MAC Control
4. If you have defined a Policy already, please choose a Policy name. The “Out Rates”
will be automatically pasted from the Policy template. You cannot change the Out
Rates if you have chosen a Policy
5. If you want to define new Data Rate, please do not choose any policies. Then you
can enter the values in the “LAN”, “WLAN”, or “WAN” Out Rates.
6. Press “Save” to save settings
7. Reboot your AP.
* If you want to control the traffic flow between MAC addresses in the same interface, please make sure both
MAC addresses are configured for the MAC Traffic Control.
Please check this part to find out what IP addresses
are supported. It varies between each mode