AirLive WL-5460AP v2 - Manual (Page 71)

AirLive WL-5460AP v2 User Manual
72
4. While pressing and holding the Reset button of WL-5460AP, connect WL-5460AP to its
power supply. Keep holding the Reset button until the red light of the Status LED goes
off.
5. Launch DOS Command Prompt and type the following commands:
CD\5460AP
tftp –i 192.168.1.6 put boot_v14a.bin
6. WL-5460AP will then reboot itself. After it has completed rebooting, open the internet
protocol setup dialog and enter IP addresses as illustrated below: