AirLive WL-5460AP v2 User Manual
Page 59
AirLive WL-5460AP v2 User Manual
60
3. Enter “1024” for the “WLAN Out Rate”
4. Enter “VIP Subscriber” for the “Comment”
5. Click on “Save” button
6. Now the “VIP” policy will show up in the “Current Policy Table”
Once finished, the administrator will be able to choose the policy “VIP” for their IP/MAC
Traffic Control.
C. Bandwidth Control by IP address
You can set the maximum bandwidth of a PC or a subscriber by using the IP Control.
Please follow the procedure below to setup IP Traffic Control
1. Please make sure the “Interface Traffic Control” is disabled
2. Before you start, please check the following area to see which client IPs are supported.
It differs between each mode.
3. Enable the IP Control
4. If you have defined a Policy already, please choose a Policy name. The “Out Rates”
will be automatically pasted from the Policy template. You cannot change the Out
Rates if you have chosen a Policy
5. If you want to define new Data Rate, please do not choose any policies. Then you
can enter the values in the “LAN”, “WLAN”, or “WAN” Out Rates.
6. Press “Save” to save settings
7. Reboot your AP.
* If you want to control the traffic flow between the IPs in the same interface, please make sure both IPs are
configured for the IP Traffic Control.
Please check this part to find out what IP addresses
are supported. It varies between each mode