Figure 5.15) – Atop Technology SE5416A User manual User Manual
Page 36
Atop Industrial Serial Device Server
SE5408A/SE5416A Series
User Manual V 1.0
36
Figure 5.15
Match these settings with your serial device:
UART Mode, Select between RS-232, RS-422, and RS-485. Note that RS-485 refers to
2-Wire RS-485 and RS-422 is compatible with 4-Wire RS-485.
Baud Rate, Select one of the baudrates from the dropdown box.
Parity/Data Bits/Stop Bits, Configure them accordingly.
Flow Control, Choose between No Flow Control, RTS/CTS (Hardware Flow Control),
and Xon/Xoff (Software Flow Control). If Xon/Xoff is selected, Xon and Xoff characters
are changeable. Defaults are 0x11 for Xon and 0x13 for Xoff. If the connecting program
or serial device would like to receive the Xon/Xoff signals also, enable
“Permit Xon/Xoff
Character Pass Through”. Enable “Xon/Xoff Special Control” to allow
synchronization between Xon/Xoff states and DSR/DTR signals.
Note:
Check “Apply to all serial ports” to execute these settings through all serial ports.