Atop Technology SE5416A User manual - Manual (Page 76)

Atop Industrial Serial Device Server
SE5408A/SE5416A Series
User Manual V 1.0
76
Figure 7.4
For setting as a TCP Client, please follow these steps.
 Click on the COMX port under Serial on the left hand side.
 Select TCP Client in the Link modes.
 Only two communication modes are available here: RAW and Virtual COM which
definitions are the same as above in Mode .
 Enter the preferred Destination IP and Port. This should match the IP settings of the
TCP Server program.
 Enable and enter Destination IP 2 and Port 2 if necessary. Two different servers can be
set here (for redundancy), the second server has to be enabled by ticking the box.
 Go to Response Behavior for more information on this setting. For serial settings, go to
Sec. 5.4.1 . For Advanced settings, go to Sec. 5.4.2 .
 Scroll to the bottom and click on “Save Configuration” button to save the changes.