Online manual not for resale purposes – BLITZ SBC i-Color User Manual

Page 19

Advertising

Installation of the MMD i-Color LCD Display

Steps:
1) Disconnect the battery.
2) Connect the harness from the LCD Display to the center harness and connect the center

harness to the CPU unit. Then connect the black wire (ground) and the red wire (power).
The red wire must be connected to a power source that can supply +12 at IGN-ON.

3) Using an electro taps, connect the:

Orange wire: Vehicle speed
Brown wire: RPM
(Take a look at the attached booklet for UCU wire diagrams)

4) Connection of optional sensors.

Connect the TEMP sensor, the PRESS sensor or the A/F sensor to the center harness.
(Only the PRESS sensor or the A/F sensor can be connected to the AUX port at once and
the voltage (FIT Value) must be calibrated).
The TEMP sensor can be displayed just by plugging.

5) Install the LCD display at a location that would not interfere while driving. Moreover,

bundle together all the wire with lock tights and double side tapes.

Center Harness (For MMD)

Red: +12V Power
Black: Ground (GND)
Orange: Speed
Signal
B

RPM Si

Controller Harness

AUX (Press

Temp

Use the Display

Back Seal to

protect the

Installation of MMD i-Color to the SBC i-D.
Instead of using the MMD i-Color’s center harness; keep using the SBC i-D’s center harness to
install the MMD i-Color to the SBC i-D. All the functions and operations will be the same as
the SBC i-Color. However, the displayed units will all be changed to hkpa.

WARNING; All images and text in this manual is the property of Blitz Co., Ltd. (Japan). No part of this maybe reproduced,
stored in retrieval systems, or transmitted in any form or means without prior written permission of Blitz Co., Ltd. (Japan).

Online Manual Not For Resale Purposes

Advertising

Popular Brands

Popular manuals