Online manual not for resale purposes – BLITZ SBC i-Color User Manual

Page 34

Advertising

Advice:
It continues to adjust itself even after the self-learning mode (Red CH mark) disappears.
The reason for this is because there are times the feedback value might greatly differ and
to compensate it, it must continuously keep self-learning.
Moreover, even if the set boost is 1.0 hkPa, the AUTO mode restrain the over shoot of the
boost by stabling the boost at 0.98 hkPa. (This is not a malfunction)

⑦

Limiter
If the boost pressure reaches the warning value, it will shift the boost to the limit
pressure set at warning.

Configuration Method
Input the desired Point Value of 1～100. (The points are the same as the MANU
Mode)
If the point value is not known, drive the car and verify the ratio between the point
value and the hkPa. Another way is to change the Boost set up screen from AUTO to
MANU and verify the point value at the MANU mode if the self-learning mode at a
CH set on AUTO mode is finished.

※

If the encoder is turned and pressed, the self-learning value will be cleared and

shift to MANU control.

EX: Prevention of over shoot

Boost set at 1.0 hkPa at AUTO mode

Warning set at 1.05 hkPa, and limiter set at 1.0 hkPa.

The MANU point value is 34 when switched from AUTO Mode 1.0 hkPa.

Therefore, set the limiter point value at 34.

WARNING; All images and text in this manual is the property of Blitz Co., Ltd. (Japan). No part of this maybe reproduced,
stored in retrieval systems, or transmitted in any form or means without prior written permission of Blitz Co., Ltd. (Japan).

Online Manual Not For Resale Purposes

Advertising

Popular Brands

Popular manuals