Online manual not for resale purposes – BLITZ SBC i-Color User Manual

Page 32

Advertising

6. Calibration Mode.

Initial setting and calibration in using the SBC or MMD

①

Speed Calibration
A selection of 2P, 4P, 8P, 16P and 40km/h are available. (A maximum capability
of 160P).
Calibration is not needed if the pulse of the vehicle is known. However, if the
pulse is not known, the “Keep 40km/h & Enter” calibration must performed to

acquire a reliable speed pulse.

Advice:
Keep performing the “Keep 40km/h & Enter” calibration until a reliable speed

pulse is acquired.

②

RPM Calibration
A selection of 3, 4, 6 cylinders and 3000 RPM are available depending on the

vehicle.
Keep the engine RPM at 3000 and press the encoder to calibrate the RPM is the
default settings cannot obtain a reliable RPM.
(A maximum capability of 18 cylinders)

③

Horsepower Calibration
Input the following 4 items by turning the encoder.
Weight of the vehicle.

100～4500 kg.

Type of drive train.

2WD or 4WD

Road resistance.

－

15～+34. (See the attached list for reference)

Wheel spin distance.

0～50 meters

Advice:
Make sure to input a data as accurate as possible for a reliable calculation.

④

Setting of Voltage Data
It sets the displayed unit value and the inputted voltage value to be displayed as

a two-point relation.
One AUX port and three external voltage inputs are available.
An optional harness is necessary for external voltage input.

Advice:
Code 19211 Press Sensor FIT value would be as follow.
Input Line AUX: Low=0.5V→FIT=0.00, High=4.5V→FIT=10.0

(FIT Value of = 10.0) X 100kPa = 1000kPa (Pressure value)
1.00psi = 6.89kPa.

WARNING; All images and text in this manual is the property of Blitz Co., Ltd. (Japan). No part of this maybe reproduced,
stored in retrieval systems, or transmitted in any form or means without prior written permission of Blitz Co., Ltd. (Japan).

Online Manual Not For Resale Purposes

Advertising

Popular Brands

Popular manuals