INFICON VGC403 Three-Channel Measurement and Control Unit - Manual (Page 5)

tinb07e1-e 2011-07 Vacuum Gauge Controller
5
1.4 Safety
1.4.1 Personnel qualifications
All work described in this document may only be carried
out by persons who have suitable technical training and
the necessary experience or who have been instructed
by the end user of the product.
1.4.2 Illustration of residual dangers
This Operating Manual illustrates safety notes concern-
ing residual dangers as follows:
NOTE:
A note such as this one indicates particularly impor-
tant, but not safety-relevant information.
1.4.3 General safety instructions
For all work you are going to do, adhere to the applicable
safety regulations.
Also observe all safety notes given in this document and
forward the information to all other users of the product.
In particular, pay attention to the following safety notes:
Fig. 1-2 Do not insert objects through louvers and keep unit dry
DANGER
DANGER indicates an imminently hazardous
situation which, if not avoided, will result in
death or severe injury.
WARNING
WARNING indicates a potentially hazardous
situation which, if not avoided, could result in
death or severe injury.
CAUTION
CAUTION indicates a potentially hazardous
situation which, if not avoided, may result in
moderate or minor injury or in property dam-
age.
DANGER
Mains power.
The Vacuum Gauge Controller contains parts
which are connected to the mains supply.
Make sure that no objects enter through the
louvers of the unit. Keep the unit dry. Do not
open the unit.
WARNING
Improper use.
Improper use can damage the Vacuum
Gauge Controller.
Use the Vacuum Gauge Controller only as in-
tended by the manufacturer. See Chapter 1.2
Intended use,  4.