2 device block state command (id 15) – INFICON SKY CDGxxxD (Profibus) User Manual
Page 26
26
tira54e1-a (2009-01) CDGxxxD.cp
There are a number of special commands for bringing the gauge into a status it
does not automatically go to.
ID Name
Structure Data type
Bytes Access
Store Range
15 Device
Block
State
Command
Simple UINT8
1 1_R/W
2_R/W
N
→ below
The device block state method allows the master to force the behavior of the
device block state machine (as shown in parameter device state) by setting it to
one of the values shown in the table below. Depending of the actual state, some
values may not be allowed at a time.
ID value
Name
Description
0 Inactive No
action.
1
Reset
Used for reinitializing the device.
2
Abort
Brings the device to the ABORT status.
3
Recover
Used for bringing the device from the ABORT
status into the Recovered State ≙ IDLE.
4
Execute
Brings the unit to the EXECUTING status, in which
the gauge functions normally. As soon as cyclic
data traffic is initialized, this status command is
executed automatically.
5
Stop
Brings the gauge to the IDLE status.
6 Perform
Diagnostic
Stops the running activity and starts SELFTEST.
7…127 Reserved
by
PNO
128…255 Manufacturer
specific
7.2.2 Device Block State
Command (ID 15)